Home >> replacement of fine aggregate with copper


replacement of fine aggregate with copper

Experimental Investigation of Concrete in Partial ...

at 40% replacement of fine aggregate by copper slag and flexural strength increased by 14 % for 40 % replacement. Many researchers have investigated worldwide on the possible use of copper slag as a concrete aggregate Jayapal Naganur and Chetan B.A.(2014) studied the compressive strength increased with increase in copper slag ...

Study on Strength of High Performance Concrete by Partial ...

refinery plants, has low cost and its application as a fine aggregate in concrete production reaps many environmental benefits such as waste recycling and solves disposal problems. Copper slag possesses mechanical and chemical characteristics that qualify the material to be used in concrete as a partial replacement as fine aggregate.

International Journal of Research (IJR) Vol , Issue ...

using copper slag as partial replacement of fine aggregate. For this research work, M20 grade concrete was used and tests were conducted. Various concrete mixtures were prepared with different proportions of copper slag as fine aggregates replacement. Concrete mixtures were evaluated for workability, compressive strength, splitting

Replacement of Natural Sand with Efficient Alternatives ...

The sieve analysis for copper slag infers that the gradation properties of fine aggregates at all the replacement levels are similar to the specification for sand zone II as per IS: 383. The sieve analysis report is shown in Table 1

Copper slag as fine aggregate for high performance concrete

The effect of copper slag addition as replacement of fine aggregate on the density of normal and high strength concretes is shown in Fig. 1. It can be seen from Fig. 1 that there is general increase in the density of both normal and high strength concretes with the increase of copper slag replacement …

Use of Bamboo & Copper Slag for Replacement of Steel ...

Use of Bamboo & Copper Slag for Replacement of Steel & Fine Aggregate - written by Bhosale Mahesh Bhimarao , Dr. Santosh K Patil published on 2019/07/01 download …

Partial Replacement of Copper Slag as Fine Aggregate

concrete with partial replacement of fine aggregate by copper slag with various percentages of 0%, 10%, 15% and 20%. The specimens were casted for 7days, 14 days and 28 days then tested. The results are presented above. V. REFERENCES ... Partial Replacement of Copper Slag as Fine Aggregate ...

A Study on Non Destructive Tests of Concrete with ...

full replacement of fine aggregate with copper slag on the strength and behavior. In this experimental study, M20, M30, M40 grade concrete was used and the tests were conducted for different replacement of fine aggregate using copper slag as 0%, 20%, 40%, 60%, 80%, and in concrete.

Study on Glass Fibre Reinforced Concrete with Partial ...

glass fibre reinforced concrete with copper slag as a partial replacement of fine aggregate. The parameters of the study included by replacing the fine aggregate by copper slag with 60% and by varying the volume fraction of glass fibre 0.5%, 1% and 1.5%. The grade of concrete is M20. The specimens were cured for 7 and 28 days.

EXPERIMENTAL INVESTIGATION ON COPPER SLAG AS FINE ...

coarse aggregate is found to be 2.63. 3.1.3 Copper slag Copper slag is one of the waste material obtained from the industry which is now behaves as a promising future for the construction industry as a fully or partial replacement of fine aggregate or cement. It is the byproduct obtained from refining of copper and matte smelting.

A STUDY ON COPPER SLAG AS REPLACEMENT OF FINE AGGREGATE ...

This paper reports an experimental program to investigate the effect of using copper slag as a complete replacement of sand on the property of fine aggregate. Addition of red soil in ratio 0%, 5%, 10% in cement.M25 mix design has been used.

Replacement of Natural Sand with Efficient Alternatives ...

The sieve analysis for copper slag infers that the gradation properties of fine aggregates at all the replacement levels are similar to the specification for sand zone II as per IS: 383. The sieve analysis report is shown in Table 1

EXPERIMENTAL STUDY ON PROPERTIES OF STRENGTH AND ...

replacement of fine aggregates in the concrete mix design. Various durability tests will be conducted on such concrete of M30 grade and M40 grade to know the compressive strength, split tensile strength, flexural strength by varying proportions of copper slag (CS) with fine aggregates by 0%, 5%, 10%,

Study on Mechanical Properties of Concreteon Partial ...

when copper slag was used to replace fine aggregate, up to 40% copper slag replacement, the strength of concrete was increases while the surface water absorption decreases. They also observed that when more than 40% of copper slag is used, the microstructure of concrete contains more voids, micro cracks, and capillary channels which accelerate ...

EXPERIMENTAL STUDY O N CONCRETE (M30) BY PARTIAL ...

split tensile strength, and flexural strengths of the M30 concrete. Here the fine aggregate partially replaced by copper slag (CS) in 20% ,30%,40% and 50% by weight of sand. Mix design was prepared for M30 grade of concrete. By replacement of copper slag as fine aggregate we can reduce the digging of river sand which effects the hydraulic structure

Influence of Copper Slag in Concrete as Partial ...

Influence of Copper Slag in Concrete as Partial Replacement for Fine Aggregate N. Vinoth Kumar1 S. K. Divya2 A. Sattainathan Sharma3 1,2,3Assistant Professor 1,2,3Department of Civil Engineering 1,2,3Valliammai Engineering College, Kancheepuram, India Abstract—Concrete is the widely used construction material.

An Experimental Investigation on Partial Replacement of ...

Abstract: The paper reports the effect of concrete using copper slag and M-sand as fine aggregate replacement. In this project work, the concrete grade M60 was selected and IS method was used for mix design. The properties of materials for cement, fine aggregate, coarse aggregate, copper slag and M-sand were studied for mix design.

Experimental Study on Concrete by Replacement of Fine ...

Experimental Study on Concrete by Replacement of Fine Aggregate with Copper Slag, GGBS and M- Sand 1R.Anusuya, 2D.Chandraleka, 3S.Sarumathi, 4G.Karthikeyan 1,2,3U.G student, 4Assistant professor Department of Civil Engineering Ramco Institute of Technology, Rajapalayam, Tamil Nadu Abstract:- Concrete is the most undisputable and

Experimental study on partial replacement of various ...

containing copper slag as a fine aggregate and concluded that the workability was increase up to 31.57 for replacement of copper slag as a fine aggregate. The maximum compressive strength of concrete increases up to 8.63% for 20% replacement of fine aggregate.They also revealed that

SCOPE OF REPLACING FINE AGGREGATE WITH COPPER …

cubes with 40% replacement of fine aggregate with copper slag shows an increase of 15% when compared to the normal concrete cube. Similarly, there was increased in the split tensile strength of concrete with 40% replacement of fine aggregate with copper slag shows an increase of 34% when compared to conventional concrete. 3. T. Ch.

International Journal of Research (IJR) Vol , Issue ...

using copper slag as partial replacement of fine aggregate. For this research work, M20 grade concrete was used and tests were conducted. Various concrete mixtures were prepared with different proportions of copper slag as fine aggregates replacement. Concrete mixtures were evaluated for workability, compressive strength, splitting

Effects of Copper Slag as Partial Replacement for Fine ...

characteristics of fly ash and GGBFS based geopolymer concrete with and without the fine aggregate replacement have been compared. The results indicated that geopolymer concrete with 40% copper slag as fine aggregate replacement showed an improvement of 17.5%, 13.94% and 22.72% in the 28th day compressive

Properties of Concrete Manufactured Using Steel Slag ...

This paper aims to study experimentally, the effect of partial replacement of coarse and fine aggregates by steel slag (SS), on the various strength and durability properties of concrete, by …

INFLUENCE OF COPPER SLAG AS PARTIAL REPLACEMENT …

concrete with copper slag fine aggregate”, The 5th CANMET/ACI International conference on durability of concrete, pp 141 – 158. 5. 5.Hwang CL, Laiw JC 91989), “Properties of concrete using copper slag as a substitute for fine aggregate”, The 3rd International conference on fly ash, silica fume, slag,

Experimental Study on concrete using Copper Slag as ...

material for fine aggregate in concrete. 2. To debrief the physical and chemical properties by use of copper slag for fine aggregate in concrete specimens. 3. To inspect the performance of concrete made with copper slag as replacement of fine aggregate. 4. …

Experimental Study on concrete using Copper Slag as ...

material for fine aggregate in concrete. 2. To debrief the physical and chemical properties by use of copper slag for fine aggregate in concrete specimens. 3. To inspect the performance of concrete made with copper slag as replacement of fine aggregate. 4. …

Effects of Copper Slag as a Replacement for Fine Aggregate ...

92 Effects of Copper Slag as a Replacement for Fine Aggregate on the Behavior and Ultimate Strength of Reinforced Concrete Slender Columns used. Table 2 shows the mix design quantities.

A Study on Effective Replacement of Fine Aggregate using ...

A Study on Effective Replacement of Fine Aggregate using Copper Slag M. R. Amarnaath S. Jaya Pradeep UG Student UG Student Department of Civil Engineering Department of Civil Engineering Knowledge Institute of Technology Knowledge Institute of Technology R. A. Kavin P. Dinesh

SCOPE OF REPLACING FINE AGGREGATE WITH COPPER SLAG …

 · Different researchers have also revealed numerous uses of copper slag as a replacing agent in determining the strength of concrete. A comprehensive review of studies has been presented in this paper for scope of replacement of fine aggregate from copper slag in concrete. Key Words: Copper slag, Fine aggregate, Review, Replacement, Concrete ...

Studies on use of Copper Slag as Replacement Material for ...

 · Abstract. This work focuses on the use of copper slag, as a partial replacement of sand for use in cement concrete and building construction. Cement mortar mixtures prepared with fine aggregate made up of different proportions of copper slag and sand were tested for use as masonry mortars and plastering.

How efficient is copper slag when it replaces fine ...

When Copper is being extracted from it’s Ore, a significant amount of unusable residue is separated called as Copper Slag. This Slag more or less possesses the properties of copper upto some extent. Therefore it can be said to have more strength o...

A Study on the Partial Replacement of Fine Aggregate with ...

materials for clinker, cement replacement, coarse and fine aggregates. The use of copper slag in cement and concrete provides potential environmental as well as economic benefits for all related industries, particularly in areas where a considerable amount of copper slag is produced.